Instruction manual

278 Encore Presentation System • User’s Guide

6. System Setup

Backup to Flash Memory Card

_~Åâìé=íç=cä~ëÜ=jÉãçêó=`~êÇ

Encore system setup: Step 20

S Prerequisites — Ensure that you are familiar with the Backup/Restore

. In Chapter 5, refer to the “Backup/Restore Menu” section on

page 188 for details.

In this procedure, you will back up your system configuration to a

Flash Memory Card.

 Use the following steps to back up your system:

1. Ensure that you have a (customer supplied) Flash Memory Card available.

2. Insert the Flash Memory Card into the Controller’s rear panel Memory Card slot.

3. In the System Keypad, press MISC to display the Miscellaneous Menu.

4. Press {BACKUP RESTORE} to display the Backup/Restore Menu.

5. On the Device line, select Ctrlr+VP+SP to perform a complete “backup.”

6. On the Controller Options line, select All.

7. Press {CHECK CARD} to display the Current Backup Menu.

~ Check the “Controller files backed up” section to confirm the types of

files present on the Flash Memory Card, if any. If files are present,

determine if you want to overwrite, or insert a new (blank) card.

~ Press {BACK} to return to the Backup/Restore Menu.

8. Press {BACKUP} to perform a backup operation to the Flash Memory Card using

the selected device(s) and options.

At the conclusion of this procedure, your system is completely backed up.

Note

You can only store one system configuration on a Flash

Memory Card.

Important

Only MMC or MMCPlus cards greater than 512MB can be

used.

SD cards cannot be used.