Instruction manual

Encore Presentation System • User’s Guide 241
6. System Setup
System Setup Sequence
póëíÉã=pÉíìé=pÉèìÉåÅÉ
This section provides a top level view of the entire Encore setup procedure, plus links to
each individual sequence.
 Preliminary steps:
1. “ID Setup and Remote Enable,” page 242.
2. “Peripheral Power Up and Status Check,” page 244.
3. “Return to Factory Default,” page 246.
 Next, set up all menus under the MISC heading:
4. “Touch Screen Calibration,” page 247.
5. “Programming EDID,” page 248.
6. “Restore from Flash Memory Card,” page 249.
 Next, set up all menus under the System heading:
7. “Router Setup,” page 250. Router setup
8. “D/A Setup,” page 254. D/A setup
9. “Input Patching,” page 255. Input Patching
10. “Destination Setup,” page 257. Destination Setup
11. “AUX Destination Setup,” page 259. Aux Destination Setup
 Next, set up all menus under the Output heading:
12. “Output Format Setup,” page 263.
13. “Sync Setup,” page 264.
14. “Genlock Setup,” page 265.
15. “Projector Setup,” page 266.
 Set up all background inputs, all primary sources and the DSK:
16. “Background Setup,” page 269.
17. “Input Setup,” page 271.
18. “DSK Setup,” page 274.
 To complete your setup:
19. “Saving the Setup,” page 277.
20. “Backup to Flash Memory Card,” page 278.
All of the above procedures are covered in the following sections.
Important
For the optimum Encore setup, it is recommended that you
follow all procedures in the order outlined below.