Instruction manual

Encore Presentation System • User’s Guide 115
4. Controller Orientation
Controller Sections
aÉëíáå~íáçå=_ìë
The figures below illustrate the Destination Bus on each Controller model.
Figure 4-11. Destination Bus, Controller SC
Figure 4-12. Destination Bus, Controller LC
Each button on the Destination Bus represents a location to which you can route some
form
of Controller (or router) output. The transitions that you perform will affect only the
selected destinations, leaving the unselected destinations as they were. The
Controller
SC
provides six destinations — the Controller LC provides 32. All destinations are
assigned using the
Destination Setup Menu. Please note:
• In Chapter 1, refer to the “A Word About Destinations” section on page 26 for
examples of each destination “type.”
• In Chapter 6, refer to the “Destination Setup” section on page 257 for details on
standard destination setup procedures.
• In Chapter 6, refer to the “AUX Destination Setup” section on page 259 for
details on Aux destination setup procedures.
Following are descriptions of each button’s function on the
Destination Bus.
Destination Buttons — press to select the desired destination. Any combination of
destinations can be selected — the buttons are
not mutually exclusive. The transitions and
switches that you perform will affect only the selected destination(s).
Clear — hold down Clear, then press the desired button to remove it as a destination. The
next transition will not be routed to it.
S If destinations 1, 2 and 3 are lit, press Clear + 2 to remove destination 2 from
the group. The next transition will be routed to destinations
1 and 3 only.
All — (Controller LC only) press All to activate all valid destinations.
• Press Clear + All to clear all valid destinations.
In Chapter 7, refer to the “
Working with Destinations” section on page 293 for complete
instructions on all destination modes.
61 2 3 4 5
DESTINATIONS
Clear
30 31 32 All1 2 3 4
Clear
DESTINATIONS
1
Clear
All