Owner's manual

RGB 168

xixi

xi • Installation and Operation 2-11

Adapter plate installation must be performed

by authorized service personnel only.

Follow these steps to install adapter plates.

1. Make sure that the power is removed from the interface

by disconnecting the AC power cord from the unit.

2. Open the cover of the interface (the top half of the

enclosure), as shown below. Remove the screws from

the enclosure, and lift the cover straight up.

Do not touch any switches or electronic

components inside the interface. Doing so

could damage the interface.

Extron

RGB 168xi

RGB 168 xi

INPUTS

AUDIO

ANALOG

UNSWITCHED

600 WATTS MAX.

MIN/MAX

UNIVERSAL INTERFACE W /ADSP

ID PIN 14

ID PIN 11

BUFFERED LOCAL

MONITOR OUTPUT

Remove #8 Screw

(4 Plcs) Each Side

and Bracket, if Present

Remove (12)

Screws

Lift Cover

Straight Up

3. Remove the blank plates from the interface by

unscrewing the nuts that fasten the plates to the inside

of the enclosure.

4. Route the adapter output cables through the rear panel

cable holes and clamps into the enclosure and out the

front panel plate openings, as shown on the facing page.

5. Attach the output cables to the rear connectors of the

front panel adapter plates. Soldering will be required

for some connectors.