Installation guide

Ä
Pull the cables through the receiver base.
1. Pull the cables to the receiver.
a. Pull the STP cable through the receiver
base, along with any other cables that will be
attached to the receiver (RS-232, STP cable
to a secondary receiver, and so on).
b. If mounting the receiver to a wall and using a
raceway, place the cables in the raceway and
replace the raceway cover.
2. Connect the cables to the receiver.
a. Connect the STP cable to the Receiver Out
port (the RJ-45 connector closest to the DIP
switches on the receiver base).
Å
Place the cables in the raceway and replace
the raceway cover.
Ç
Connect the STP cable to the Receiver Out
RJ-45 port.
Procedure
VoiceLift System with PVS 405D Installation Guide • Installation — Stage 4 29