Installation guide

Stage 3:
Installing the
PoleVault Switcher
This stage consists of installing the PVS 405D PoleVault Switcher (VLS only). See the
PoleVault Systems Featuring the PVS 405D Switcher Installation Guide, delivered with
your PVS 405D switcher and also available at www.extron.com, for complete switcher
installation procedures.
PVS 405D PoleVault Switcher
Figure 15. PVS 405D Switcher, Cable, and Power Supply
Where it goes: The PVS 405D and power supply can be installed in the
following locations:
• A projector ceiling pole, with an Extron PMK 560 Pole Mount Kit
• A table top, cabinet, or shelf (Attach the four provided rubber
feet to the bottom of the unit.)
• On a wall, with an Extron WMK 160 WallVault Wall Mount Kit
What it does: Receives input video and audio signals from A/V source input
wall plates and audio signals from the VoiceLift VLR 102 Receiver.
Outputs and switches the signals to a projector and ceiling
speakers.
L R
DO NOT
GROUND
OR SHORT
SPEAKER
OUTPUTS
4/8
Ω
3A MAX
POWER
12V
HDMI
1/2
SIG LINK SIG LINK
3/4
INPUTS
OUTPUT
AUDIO OUT
PVS 405SA IP
AMPLIFIED AUDIO OUT
PAGING
SENSOR
PVT IN
PVT IN
L
R
AUX
OVER PVT
REMOTE
VOICELIFT
LAN 1 LAN 2 LAN 3
INPUT 5
+V
L
R
RS-232
Tx Rx
IR
S G G
LR
DO NOT
GROUND
OR SHORT
SPEAKER
OUTPUTS
4/8
Ω
3A MAX
POWER
12V
HDMI
1/2
SIG LINK SIG LINK
3/4
INPUTS OUTPUT AUDIO OUT
PVS 405D
AMPLIFIED AUDIO OUT
PAGING
SENSOR
PVT IN PVT IN
L
R
AUX OVER PVT REMOTE
VOICELIFT
LAN 1LAN 2LAN 3
INPUT 5
+V
L
R
RS-232
Tx Rx
IR
SG G
Po
wer Supply
Connector
VoiceLift
Receiver Port
Audio Out
Port
Output to
Speaker
Paging
Sensor
Port
VoiceLift System with PVS 405D Installation Guide • Installation — Stage 326