Installation guide

Stage 1b — Installing the Receiver to a Junction Box
1. Install the junction box.
• Install the junction or ceiling box (not included)
flush with the mounting surface (follow the
instructions provided with the junction box).
• Use a one-gang plaster ring (Raco772) if the
junction box is larger than one-gang.
WARNING: Risk of electric shock. Improper
installation may result in electrical shock
or serious injury. All electrical installation
should be performed by qualied personnel
in accordance with local and national
building codes, re and safety codes, and
local and national electrical codes.
2. Attach the receiver housing to the junction
box.
a. Align the receiver housing with the junction
box.
b. Secure the housing in place with the
appropriate screws (not included).
3. Attach a conduit to the junction box if
needed.
NOTE: Observe all local and national building
and safety codes.
a
Attach the junction box flush with the
mounting surface.
É
Attach the receiver housing to the junction
box.
Mounting Screws
Junction Bo
x
Mounting
Holes (2)
Ceiling Box
Mounting
Holes (2)
Plaster
Ring
c
Attach a conduit to the junction box if
needed.
VoiceLift System with PVS 405D Installation Guide • Installation — Stage 118