Installation guide

Stage 1:
Mounting the
Receiver
This stage consists of installing the VLR 102 receiver in a drop ceiling or on a wall.
Receiver Housing and Back Plate
Raceway Knockouts (2
)
Conduit Knoc
kouts (2)
Receiver
Housing
Back Plate
Figure 9. Receiver Housing and Back Plate
Where it goes: The housing attaches to the receiver dome, and the back plate
mounts to a ceiling tile or a wall.
What it does: Protects the receiver base plate and connectors. The housing
contains knockouts for different sizes of raceways, and the back
plate contains knockouts for a conduit.
Z-bracket and Mounting Screw (for Installation in a Drop Ceiling)
Z-bracket
Mounting Screw
Figure 10. Z-bracket and Mounting Screw
Where it goes: The mounting screw passes through the receiver back plate, then
through the hole in the ceiling tile. The bracket is attached to
the screw on the back of the ceiling tile.
What it does: Fastens the receiver to a tile in a drop ceiling.
VoiceLift System with PVS 405D Installation Guide • Installation — Stage 1 15