Installation guide

VoiceLift System with PVS 405D Installation Guide • Introduction 9
Inventory
The VoiceLift VLS System kit is available in three packaged congurations:
• VLS 1000D: Contains one VLP 102 Pendant Microphone, a VLR 102 Receiver, a
wall charger, and two FF 120 Flat Field speakers.
• VLS 2000D: Contains two VLP 102 Pendant Microphones, a VLR 102 Receiver, a
wall charger, a VLC 102 Charging Station, and two FF 120 speakers.
• VLS 2000DH: Contains one VLP 102 Pendant Microphone, one VLH 102 Handheld
Microphone, a VLR 102 Receiver, a wall charger, a VLC 202 Charging Station, and
two FF 120 speakers.
VoiceLift VLS 1000D or VLS 2000 System
42-239-01 or 42-239-02
PVS 305SA
PoleVault Switcher
(1) 2-pole Captive Screw Connector
(3) 3-pole Captive Screw Connector
(2) 5-pole Captive Screw Connector
(1) Audio Connector, 4-pole
(4) Tie Wraps
(4) Rubber Feet
PVS 305SA
POLEVAULT SWITCHER
INPUT SELECTION
1
2
PEAK
NORMAL
SIGNAL
CONFIG
34
5
AUX AUDIO
AUDIO LEVEL ADJUST
PAGING
SENSOR
SENSITIVITY
VOICELIFT
MIC
PEAK
NORMAL
SIGNAL
INPUT
(1) Power Supply
(1) Power Cord
(2) FF 120 Speakers
FF 120
42-120-03
(2) Cable Clamps – Anchor Ring
(2) T-rails
Z Bracket and Screw
50 feet (15.2 m)
STP Cable
VLP 202
Pendant Microphone (1 or 2)
VLR 102
IR Receiver
VLC 202
Charging Station
(VLS 2000 only)
Wall Charger/
Power Supply
AA Rechargeable
Battery (1 or 2)
100 feet (30.4 m) Speaker Cable
Microphone Label Set
Mic 1
Teacher
Student
Mic 2
VoiceLift User Installation Card
VoiceLift
™
Microphone
User Installation
Card
Lanyard and
Lanyard Clip
(1 or 2)