User Guide

PowerCage FOX SR HDMI Scaling Receiver • Remote Control 14
Symbol Definitions
]
= CR/LF (carriage return/line feed)
} = Carriage return (no line feed)
| = Pipe (can be used interchangeably with the } character)
•
= Space (hard) character
E = Escape key (hex 1B)
W = Can be used interchangeably with the E character
X! = Mute status 0 = off (unmute) 2 = on (mute video)
1 = on (mute video and sync)
X@ = Contrast and brightness 000 through 255 (default 128)
X# = Detail 000 through 128 (default 64)
X$ = Horizontal and vertical position Range depends on selected output size
X% = Size Range depends on selected output size
X^ = Aspect ratio 1 = fill 2 = follow
X& = Scaler resolution (EDID) See the table on page 17.
X* = HDMI output format 0 = Auto (HDMI 444 or DVI 444) 4 = HDMI YUV 444 Full
1 = DVI 444 5 = HDMI YUV 444 Limited
2 = HDMI RGB 444 6 = HDMI YUV 422 Full
3 = HDMI RGB 444 Limited 7 = HDMI YUV 422 Limited
X( = Screen saver mode 1 = Black screen (default)
2 = Blue screen with on-screen display
X1) = Screen saver timeout 000 = No screen saver 001 to 500 (seconds)
501 = Never timeout (default)
X1! = Screen saver status
0 = Input active, timer not running 1 = No active input, timer running
2 = No active input, output sync disabled
X1@ = On and off status 0 = off 1 = on
X1# = Memory preset number 01 to 30
X1$ = Test pattern 0 = none 3 = 4x4 crosshatch
1 = color bars 4 = alternating pixels
2 = grayscale 5 = crop
X1% = Rx link and daisy chain enable 0 = disable 2 = daisy chain enable
1 = return link enable
X1^ = Video delay (0 plus six steps at 0.25 seconds per step) 0 = 0 second 4 = 1.0 second
1 = 0.25 second 5 = 1.25 second
2 = 0.5 second (default) 6 = 1.5 second
3 = 0.75 second
X1& = Switch position 0 = off (right) 1 = on (left)
X1* = Link status 0 = light or signal input not detected 1 = light or signal detected
X1( = Temperature nnnF•nnC
X2) = Vendor/manufacturer name
X2! = Transmit output power in milliwatts
X2@ = Receive optical power in milliwatts
X2# = SFP temperature nnC
X2$ = Transmission mode SM = singlemode MM = multimode
X2% = Firmware version v.vv