Specifications

11822 / Newcomb Academy 27 4116.51 - 8 AUDIOVISUAL POLE VAULT SYSTEMS
FOR
6-18-13
4. The projector bracket shall also use a 1.5” NTP (National Tapered Pipe) threaded pipe
adapter for mounting a projector pole.
5. The projector bracket should also maintain positioning adjustments even if the projector is
removed for service.
6. The bracket should also feature security flanges that enable the entire unit to be locked to
prevent theft.
7. Accessories:
a. Security Bar
b. Cable Lock System
PART 3 – EXECUTION
3.01 EXAMINATION
A. Verify that related conditions, including equipment that has been previously installed under other
sections, are acceptable for product installation in accordance with manufacturer’s instructions.
B. All devices connected to equipment specified in this section shall bear the UL label and comply
with the applicable National Electrical Code (NEC) standards
3.02 INSTALLATION
A. All equipment and enclosures described in this specification shall be installed plumb and square
per manufacturer’s instructions.
B. All equipment, except that designated as movable, portable or loose equipment, shall be
secured and permanently attached to the permanent structure in a manner which will require the
use of a tool (e.g.: screw driver, nut driver, etc.) for removal.
C. All supports shall meet or exceed the load requirements of the intended application with a
minimum safety factor of five (5).
D. Provide support structure and hardware with a SAE Grade 8 load rating (min.).
E. Classroom AV integrator shall test with installing Active Infrastructure contractor and confirm
correct port placement, functionality for the appropriate VLAN and their overall system
functionality.
F. Classroom AV integrator shall coordinate with the Digital Intercom Clock and Bell System
contractor for the installation of the priority page sensor with the clock and bell system.
G. Integrator shall furnish all equipment, labor, system setup, and other services necessary for the
proper installation of the products/system as indicated on the drawings and specified herein.
System setup information shall include each components proper mounting and alignment and
properly verified signal pathways and operation. Proper operational and network support control
functions shall be verified.
H. Install in accordance with manufacturer’s handling and installation instructions.
I. Install in accordance with all local and pertaining codes and regulations
J. Utilize an Integrator with demonstrated experience in projects of similar size and complexity.
K. Equipment shall be configured and in ready to use condition at the end of installation.
L. Energize and commission equipment in accordance with manufacturer’s instructions.
Commissioning the system shall at minimum, consist of the following:
1. Install Global Configurator software on PC
a. Download from www.extron.com, or install from Extron Software Products CD.
2. Make the following MLC cable connections:
a. Power
b. Local Area Network (LAN)
c. Classroom Source Devices
3. Configure MLC 104 IP Plus Series using Global Configurator
4. Download device drivers for all source and projection devices
5. Create a new Global Configurator project file
6. Add a device and set its IP address