Specifications

11822 / Newcomb Academy 27 4116.51 - 7 AUDIOVISUAL POLE VAULT SYSTEMS
FOR
6-18-13
1. The priority page sensor allows the PVS305SA Pole Vault Switcher to mute program audio
during announcements from a public address system
D. Wireless Microphone System
1. VLS 2000H Pendant and Handheld VoiceLift System:
a. Each microphone shall have volume control, a power switch and an auxiliary input to
use for a MP3 player or other audio source.
E. VoiceLift Wireless IR Receiver
1. The receiver has a round base with dome shaped translucent cover. This allows for
surface mounting on the ceiling and concealed wiring above the ceiling using plenum rated
cables run to the dedicated VoiceLift Receiver input of the PVS Switcher.
2. This device acts as the receiver of up to two room microphones and transmits their audio
signal to the PVS Switcher for mix into the program content of presented material. The
receiver has a contact closure that when wired and configured to the digital input of the
MLC, can trigger instant alert messages to a designated text or email account.
3. This device installation must not exceed 12’ above finished floor per manufacturer’s
recommendation.
F. VoiceLift Wireless IR Microphone Charging Station
1. This device is constructed of high impact ABS plastic and acts as a holding and charging
station of up to two of the Extron VoiceLift wireless IR microphones. It ships with its own
power supply that acts as a recharging station for the two microphones.
G. TV Tuner Media Box
1. AverMedia Model AVerTV Hybrid TVBox 11.
2. Media TV Box shall have the following output signal of DVI-I/VGA single link, Audio Output,
Composite (RCA), S-Video, Component (YPbPr; 1080i).
3. Media TV Box shall have input signals DVI-I/VGA Single Link, 75 ohms TV Antenna,
Composite (RCA), S-Video, PC Audio, Component (YPbPr; 1080i).
4. Connect audio and video out from the Aver Media TV Box to an Extron VGA input module
and connect to Extron PVS305SA-IP Switcher.
5. Media TV Box shall support NTSC/ATSC/QAM video signal, 1900 x 1200 (WXUGA) video
resolution, 16:9 and 16:10 widescreen format, and Closed Caption.
H. Projector
1. Casio Lamp Free Signature Model XJ-M255 LED DLP Projector
2. Brightness: 3000 lumens.
3. Light Source: Laser and LED Hybrid.
4. Projector shall have input signals RGB/Component video, mini D-Sub 15 pin, HDMI,
Composite Video RCA, S-Video.
5. Projector shall have Control terminal RS232C and mini D-Sub 9 Pin connector.
6. Projector shall be 3D and wireless LAN capable.
7. Warranty shall be 3 years parts and labor plus 3 years or 6,000 hours usage on the light
source.
8. Projector shall support 16:9 and 16:10 widescreen format
9. Video Signal Compatibility – NTSC/PAL/PAL-N/PAL-M/PAL60/SECAM; DTV/HDTV
480i/480P/576i/576P/720P/1080i/1080p
10. Power usage – operating power 150w (in Eco mode), 190w (Eco mode off, bright setting)
11. Projector shall have manual focus and 1.5x manual zoom
12. Contrast ratio 1800:1
I. Projector Security Locking Device
1. BMS Model LCD LOC IV Universal Projector Locking Bracket.
2. The BMS Universal Projector mount bracket shall be able to support projectors up to 25
pounds.
3. The projector bracket must have independent adjustments of horizontal tilt or roll (± 15
degrees of horizontal tilt), vertical angle or pitch (± 15 degrees of vertical angle), and
rotation or yaw (360 degrees of rotation).