Specifications

AUDIOVISUAL SYSTEMS 27000 pg (6)
7. Energy Efficiency
The audio video system shall incorporate energy conservation features to reduce consumption and lower
operating costs.
a. The system shall incorporate an Auto Power Save Mode with fast power-up that automatically deactivates
the audio amplifier after 30 minutes of inactivity. It quickly returns to full power status in less than one
second upon signal detection
b. The system shall incorporate a Standby Mode that allows the amplifier and twisted pair transmitters to be
deactivated when not in use.
c. The system shall incorporate monitoring and scheduling of system peripherals, such as sources and
displays, in order to deactivate them when not in use or alert to unauthorized use.
3 PART 3 - EXECUTION
3.1 GENERAL
A. All equipment and enclosures described in this specification shall be installed plumb and square per manufacturer’s
instructions.
B. All equipment, except that designated as movable, portable or loose equipment, shall be secured and permanently
attached to the permanent structure in a manner which will require the use of a tool (e.g.: screw driver, nut driver, etc.)
for removal.
C. All supports shall meet or exceed the load requirements of the intended application with a minimum safety factor of
five.
D. Provide support structure and hardware with a SAE Grade 8 load rating (min.).
3.2 ACCEPTABLE MANUFACTURERS - SYSTEMS
A. Manufacturer
RGB Systems, Inc, dba Extron Electronics
1230 South Lewis Street
Anaheim, Ca 92805
714.491.1500 or 800.633.9876
B. E-Rate Eligible System
PVS 200IP Plus - Two Input PoleVault IP Plus System part number 80-200-13
PVS 300IP Plus - Three Input PoleVault IP Plus System part number 80-300-13
PVS 400IP Plus - Four Input PoleVault IP Plus System part number 80-400-13
WVS 200IP-ST - Two Input WallVault IP, short throw part number 80-210-13
WVS 300IP-ST - Three Input WallVault IP, short throw part number 80-310-13
WVS 400IP-ST - Four Input WallVault IP, short throw part number 80-410-13
WVS 210IP-WM - Two Input WallVault IP, wallmount part number 80-220-03
WVS 310IP-WM - Three Input WallVault IP, wallmount part number 80-320-03
WVS 410IP-WM - Four Input WallVault IP, wallmount part number 80-420-03
C. Substitutions: Exceptions to the specifications are not acceptable. No substitutions are permitted.
D. All equipment part numbers shall be listed in the bill of materials and the system drawings specifications.
3.3 EXAMINATION
A. Site Verification of Conditions: Verify that related conditions, including equipment that has been previously installed
under other sections, are acceptable for product installation in accordance with manufacturer’s instructions.