User Manual

2-17

PoleVault Systems Installation • Installation — Stage 3

The installation must conform to national and

local electrical codes, and UL requirements.

Refer to the device’s user manual for details.

1. Cut ceiling tile

If installing PV SI 3C LP speakers, do the following:

a. Remove the ceiling tiles where the speakers are to be

installed.

For ease of working on the speaker when it is replaced

on the T-bar, remove an adjacent tile(s).

b. Locate the tile center, and using the supplied template,

trace and cut the holes for the speakers.

Place an empty box under the tile for support and to

collect the waste.

Measure and mark the center point of the tile and align

the cross marks with those on the supplied template.

Use a ﬁne hacksaw blade to cut the tile without

damaging the face.

2. Install the speaker in the ceiling tile

a. Lay two supplied speaker V-rails across the tile on either

side of the hole.

b. Remove the C-ring from the speakers and attach it to the

center of the V-rails with the supplied hardware.

At the ends of each V-rail, bend the tabs upwards.

This makes it easier when replacing the tile back on the

T-bars. When installation is complete, bend the V-tabs

down onto the T-bars

c. Remove the plenum cover from the speaker terminals

d. Insert the speaker into the ceiling tile from the face side.

Mark the tile and cut the hole

Remove plenum cover

Loosen the screws and

remove the plenum cover.

Place the V-rails on either side of the

hole, insert and

attach the C-ring

Bend Tabs

Upwards

Bend the end tabs upwards.