User Manual

2-5

PoleVault Systems Installation • Installation — Stage 1

4. Cut the ceiling tile

a. Mark the location of the PCM 240 on the T-bar, before

removing it. This aids putting it back in the correct

location when the tile is replaced.

Mark the screen direction on back of the tile (e.g. with

an arrow or “to front”) to help orientation of tile when

replacing it after cutting.

b. Measure the distances X and Y (see gure) from the inner

vertical section of the front and left T-bar runners to the

center of the Pipe Adapter Plate.

c. Using these dimensions, mark and cut a hole for the

PMP in the ceiling tile.

Place the tile on a box, mark the hole’s center on the

underside of the tile. Use a hole saw bit to start to cut

the hole by hand (turning bit counter clockwise) to

avoid damaging the tile. When the drill bit is through

the tile, turn the tile over and ﬁnish cutting from the

top side.

5. Finish Projector Ceiling Mount

installation

a. Loosen the set screws and unscrew the UPB 25 from the

mounting pole. Do not remove the projector bracket

from the projector.

b. Loosen the PCM 240 ‘s set screw and remove the

mounting pole, then remove the PCM 240.

c. Replace the cut ceiling tile, checking the orientation to

align the hole with the PCM 240.

d. Replace the PCM 240 over the ceiling tile and screw

the mounting pole (with the access hole uppermost) up

through the hole into the mounting plate. Tighten the set

screws.

T-bar

Minimum and

Maximum

Throw Distance Marks

Take measurements with the PCM 240

on the T-bar

Screw the PMP into the mounting plate

(viewed from below)

Mark and start cutting the hole on the

underside. Finish on the top side.