Manual

6.— Finish Projector Drop Ceiling Mount

Installation

a. Detach the projector bracket and projector

from the adjuster plate. DO NOT remove the

projector bracket from the projector.

b. Unscrew the adjuster plate from the mounting

pole.

c. Loosen the set screws on the PCM 340 and the

pipe location screw and remove the mounting

pole, then loosen the T-frame securing screws

and remove the PCM 340 from its marked

location.

d. Replace the cut ceiling tile, checking the

orientation to align the hole with the

PCM 340.

e. Replace the PCM 340 over the ceiling tile, slide

the slotted pipe up through the tile and into

the adapter plate. Realign the location holes

with the pipe holes, insert and tighten down the

location screw. Tighten the set screws.

f. Tighten the four T-frame securing screws on the

PCM 340. The T-frame securing screws can be

used on either side of the frame.

Slide the pipe up through the ceiling tile and

into the pipe adapter plate. Shown as viewed

from below.

PoleVault IP Systems • Installation — Stage 1 (Screen and Projector) 17