Manual

Outline of Installation Steps for PlenumVault Digital Systems (PVM 220)

Stage 1 — Install the Screen and Projector.

c Mark the screen location (page 18).

c Install projector to verify location (page 18).

c Verify the image location (page 21).

c Cut the ceiling tile (page 22).

c Preliminary safety hardware installation (page 22).

c Finish projector drop ceiling mount installation (page 23).

c Secure the projector drop ceiling mount to the ceiling (page 24).

c Install the electrical box (if required) (page 25).

c Install the screen (page 25).

Stage 2 — Mount the PVT Wall Plates and the MLC 104 IP Plus.

Install the mud rings (page 29).

c Pull cables (at the input locations) (page 30).

c Install the wall plates (page 31).

c Install the MediaLink Controller (page 32).

Stage 3 — Install the FF 120 Speakers.

c Cut the ceiling tile (page 36).

c Install the speaker on the drop ceiling (page 36).

c Terminate the speaker cable for the PVS switcher (page 38).

Stage 4D — Install the PVM 220 and PVS 405D.

c Remove the device mounting plate from the access door (page 53).

c Remove ceiling tile and install suspension cables (page 53).

c Suspend the main PVM 220 enclosure from the ceiling (page 54).

c Run AC power wiring to the AC module in the PVM 220 (page 55).

c Run signal and control cables to the PVM 220 (page 56).

c Install devices onto the device mounting plate (page 57).

c Cut and install ceiling tile into the access door (page 57).

c Install the mounting plate onto the access door (page 58).

c Cable the switcher (page 58).

c Verify and configure the setup (page 59).

Attach the door tether to the door (page 59).

c Secure the door latches (page 59).

Stage 5 — Conﬁgure the PoleVault Switcher and the System.

c Configure the switcher — PCS Configuration program (page 61).

c Configure the system — Global Configurator (page 62).

c Test the system (page 63).

c Final installation (page 65).

PoleVault Digital Systems • Installation Overview 75