Specifications

Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
09-05
68-1438-01
REV. B
© 2009 Extron Electronics. All rights reserved. All trademarks mentioned are the property of their respective owners.
Specifications are subject to change without notice.
IP INTERCOM
Connection type (IPIMLC) ................................ RJ-45 jack for CAT 5, CAT 5e, or CAT 6 cable
Audio
Frequency response .......................................... 20 Hz to 3.3 kHz, ±1 dB
Audio processing
Audio format ................................................. PCM, µ-law companded
Audio output
Number/signal type ........................................... 1 mono (for use with an optional IP Intercom)
Line level output ................................................ -10 dBV (316 mVrms), unbalanced (via 3.5 mm captive screw
connector, 2 pole)
Communication
Transport bandwidth for IPI control
and audio, half duplex ........................................ 80 kbps (0.08% of 100Base-T)
Ethernet protocol ............................................... TCP/IP (control), UDP (audio)
CONTROL — HOST PORTS
Serial host port ................................................ 2 bidirectional RS-232: 1 rear panel 9-pin female D connector
(shared with digital input), 1 front panel 2.5 mm mini stereo
jack
Baud rate and protocol .................................... 38400, 8 data bits, 1 stop bit, no parity
Serial control pin configurations ..................... 9-pin female D connector: 2 = TX, 3 = RX, 5 = GND
Mini stereo jack: tip = TX, ring = RX, sleeve = GND
Ethernet host port ........................................... 1 RJ-45 female
Ethernet data rate (for network
communication) .............................................. 10/100Base-T, half/full duplex with autodetect
Ethernet protocol ............................................. ARP, DHCP, ICMP (ping), TCP/IP, Telnet, HTTP, SMTP
Ethernet default settings ................................. Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Default gateway = 0.0.0.0
DHCP = off
Web server ...................................................... Up to 200 simultaneous sessions
7.25MBnonvolatileusermemory
Secondary control panel (SCP) ........................ (1) 3.5 mm 5-pole direct insertion captive screw connector
(shared with control module and IR Link port)
IR remote control ............................................. IR 402 (optional)
Front panel: 30' maximum, 40 degrees off axis
Rear panel: 38 kHz, hardwired, modulated
Program control .............................................. Extron's configuration program for Windows
®
Extron's Simple Instruction Set (SIS
™
)
Microsoft
®
Internet Explorer, Telnet
IR learning frequencies ................................... 30 kHz to 62 kHz
IR learning distance ........................................ 2" (5.1 cm) to 12" (30.5 cm) from the front panel
CONTROL — RELAY
Number/type ................................................... 6 momentary or latching (configurable via software)
Contact rating .................................................. 24 V, 1 A
CONTROL — SERIAL PORTS
Display control port ......................................... (1) 3.5 mm direct insertion captive screw connector, 3 pole,
programmable for bidirectional RS-232 control (±5 V) or TTL
level (0 to 5 V) infrared control up to 1 MHz
Switcher control port....................................... (1) 3.5 mm direct insertion captive screw connector, 3 pole,
for bidirectional RS-232 control (±5 V)
Baud rate and protocol (RS-232) .....................115200to300baud(9600baud=default);8(default)or7
data bits; 1(default) or 2 stop bits; no parity (default), or even
or odd parity
CONTROL— IR/SERIAL PORTS
IR/serial control ports ...................................... (3) 3.5 mm direct insertion captive screw connectors, 2 pole
Programmable: unidirectional RS-232 (±5 V) control, or TTL
level (0 to 5 V) infrared control up to 1 MHz
Baud rate and protocol .................................... 115200to300baud(9600baud=default);8(default)or7
data bits; 1(default) or 2 stop bits; no parity (default), or even
or odd parity
DIGITAL I/O CONTROL
Number/type ................................................... 1 digital input/output (configurable), 1 digital input
Digital inputs
Input voltage range ............................................ 0-12 VDC
Input impedance ................................................ 28k ohms
Programmable pullup ......................................... 2k ohms to +5 VDC
Threshold low to high ......................................... >2.8 VDC
Threshold high to low ......................................... <2.0VDC
Digital output ................................................... 250 mA sink from 24 VDC, maximum
GENERAL
External power supply ..................................... 100 VAC to 240 VAC, 50/60 Hz, external; to 12 VDC, 1 A,
regulated
Power input requirements
MLC 226 IP DV+ ............................................... 12 VDC, 0.515 A (includes MLC 226 IP and IRCM-DV+)
All other models ................................................ 12 VDC, 0.495 A (0.515 A with 1 IRCM-DV+ connected)
NOTE: An MLC 226 Series controller must be powered by its own power supply. It cannot be powered by an
MLS switcher.
Temperature/humidity ..................................... Storage:-40to+158˚F(-40to+70˚C)/10%to90%,
noncondensing
Operating: +32 to +122 ˚F (0 to +50 ˚C) / 10% to 90%,
noncondensing
Rack mount
MLC 226 IP DV+ ............................................... No, but wall- and furniture-mountable
All other models ................................................ Yes, with optional rack mounting kits, and also wall- and
furniture-mountable with optional mounting kits
Enclosure dimensions
MLC 226 faceplate ............................................ 4.5" H x 6.4" W x 0.1" D
(11.4 cm H x 16.3 cm W x 0.3 cm D) (3 gang)
MLC 226 AAP, MLC 226 IP DV+ faceplates ......... 4.5" H x 10.0" W x 0.1" D
(11.4 cm H x 25.4 cm W x 0.3 cm D) (5 gang)
MLC 226 L faceplate ......................................... 3.15" H x 6.5" W x 0.1" D
(8.0 cm H x 16.5 cm W x 0.3 cm D)
Device
MLC 226 IP DV+ ...........................................2.75"Hx5.3"Wx2.0"D
(7.0cmHx13.5cmWx5.9cmD)and
2.7"Hx2.6"Wx0.9"D(6.9cmHx6.6cmWx2.3cmD)
(Depth excludes knob and buttons. Fits some 5 gang boxes.
Allow at least 2.1" (5.3 cm) depth in the wall or furniture.)
All other models ............................................ 2.75"Hx5.3"Wx2.0"D
(7.0cmHx13.5cmWx5.9cmD)
(Depth excludes knob and buttons. Fits some 3 gang boxes)
Product weight
MLC 226 IP DV+ ............................................... 2.1 lbs (1.0 kg)
All other models ................................................ 1.9 lbs (0.9 kg)
Shipping weight .............................................. 6 lbs (3 kg)
Vibration .......................................................... ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety ............................................................... CE, C-tick, CUL, UL
EMI/EMC ........................................................... CE, C-tick, FCC Class A, VCCI, ICES
Accessibility ...................................................... Complies with the appropriate requirements of Section 508 of
theRehabilitationAct(29U.S.C.794d).
MTBF ............................................................... 30,000 hours
Warranty .......................................................... 3 years parts and labor
NOTE: All nominal levels are at ±10%.
Model Version Description Part Number
MLC 226 IP Controller w/Three-Gang Faceplate .................. 60-600-0X
MLC 226 IP AAP Controller w/AAP Opening ............................... 60-600-1X
MLC 226 IP DV+ Controller w/Integrated DVD & VCR Control ...... 60-600-82
MLC 226 IP L Controller w/Lectern Faceplate ......................... 60-600-3X
Included Accessories
MLC 226 IP / MLC 226 IP DV+ / MLC 226 IP AAP / MLC 226 IP L
12V/1Amp power supply ............................................................................ 70-055-01
Button label text ........................................................................................ 33-954-01
Button label icon ........................................................................................ 33-955-01
Specifications
MLC 226 IP