User Guide User Manual

ManualsBrandsExtron Electronics ManualsAccessories for videoMVX VGA A

Table of Contents, cont’d

MVX VGA A Matrix Switchers • Table of Contents

PRELIMINARY

Setting the front panel locks (Executive modes) ................................................................3-36

Selecting Lock mode 2 or toggling between mode 2 and mode 0 ................................3-36

Selecting Lock mode 2 or toggling between mode 2 and mode 1 ................................3-37

Performing a system reset from the front panel................................................................3-37

Selecting the rear panel Remote port protocol and baud rate ....................................... 3-38

Rear Panel Operations ........................................................................................................... 3-40

Performing an absolute system reset from the rear panel ............................................... 3-40

Performing a hard reset from the rear panel ..................................................................... 3-41

Optimizing the Audio ............................................................................................................ 3-41

Troubleshooting ........................................................................................................................ 3-42

Conﬁguration Worksheets .................................................................................................3-42

Worksheet example 1: System equipment .......................................................................... 3-42

Worksheet example 2: Daily conﬁguration.........................................................................3-43

Worksheet example 3: Test conﬁguration ..........................................................................3-44

Conﬁguration worksheet ....................................................................................................... 3-45

Chapter Four • Programmer’s Guide ..................................................................................4-1

Serial Ports ..................................................................................................................................... 4-2

Rear panel Remote port ...........................................................................................................4-2

Front panel Conﬁguration port .............................................................................................. 4-3

Host-to-Switcher Instructions ............................................................................................. 4-3

Switcher-Initiated Messages ...............................................................................................4-3

Switcher Error Responses ..................................................................................................... 4-4

Using the Command/Response Table .............................................................................4-4

Command/Response Table for SIS Commands .........................................................4-5

Symbol deﬁnitions ....................................................................................................................4-5

Command/response table for SIS commands ........................................................................ 4-6

Chapter Five • Matrix Software .............................................................................................5-1

Matrix Switchers Control Program .................................................................................5-2

Installing the software .............................................................................................................5-2

Using the Matrix Switcher Control software ........................................................................5-3

Updating ﬁrmware ...................................................................................................................5-6

Windows buttons, drop boxes, and trash can ....................................................................5-10

Windows menus ......................................................................................................................5-10

File menu ...........................................................................................................................5-10

Tools menu ......................................................................................................................... 5-11

Preferences menu ..............................................................................................................5-12

Master-Reset

selection .......................................................................................................5-12

Using Emulation mode ...........................................................................................................5-13

Using the help system ............................................................................................................5-13

Button-Label Generator Program ..................................................................................5-13

Using the Button-Label Generator software ......................................................................5-14