Setup guide

ii
SMX System MultiMatrix Switchers • Table of Contents
Table of Contents, cont’d
Also refer to the SMX System MultiMatrix Switchers User’s Manual at www.extron.com.
68-1452-50
Rev. A
02 09
All trademarks mentioned in this manual are the properties of their respective owners.
Chapter Four • SIS
™
Programmer's Guide ......................4-1
Selected SIS
™
Commands ............................................................4-2
Establishing a network (Ethernet connection ......................4-2
Connection time-outs .............................................................4-2
Number of connections ..........................................................4-2
Verbose mode .........................................................................4-2
Host-to-switcher instructions ................................................4-3
Error message
s ........................................................................4-3
EDID — Extended Display Identication Data
.....................4-3
SIS Command Tables ......................................................................4-4
Chapter Five • Conguration and Control .....................5-1
Installing and Starting the SMX Control Program ...........5-2
Installing the program ...............................................................5-2
Starting the program .................................................................5-3
Accessing the HTML Pages .........................................................5-4
Using the Web Pages to Congure the SMX ......................5-5
Status Page ............................................................................. 5-5
Conguration
Page ....................................................................5-6
File Management Page ..............................................................5-6
Control Page ................................................................................5-6
Appendix A • Reference Material ......................................... A-1
Cabling and Connector Wiring ................................................A-2
Choosing a network cable ........................................................ A-2
Terminating the network cable ............................................... A-2
Wiring audio connectors ..........................................................A-3
Installing the Input/Output Boards .......................................A-4
Installing new boards into an empty SMX frame ................ A-4
Replacing an existing SMX I/O board ..................................... A-4