Setup guide

SMX System MultiMatrix Switchers • Front Panel Operation
3-7
Also refer to the SMX System MultiMatrix Switchers User’s Manual at www.extron.com.
Saving or recalling a plane preset
ENTER
Step 5 – Press the Enter button to save or recall the plane preset.
Current configuration is saved to plane preset 3 and all buttons turn off.
C O N T R O L
PRESET
ESCVIEW
Step 4 – (To save) Press and release the desired input button (here plane preset 3).
– (To recall) Press and release the desired lit input button.
Selected button flashes red. Enter button also blinks (red).
INPUTS
1
2
3 4
5
6 7 8
9
10
11 12
13 14 15 16
OUTPUTS
1
2
3 4
5
6 7 8
9
10
11 12 13 14 15 16
N At this time all global presets go out and any saved plane presets
light red (here plane preset #7).
I/O PLANE SELECT
1
2
3 4
5
6 7 8
9
10
11 12 13 14 15
0
Step 3 – Press the desired plane button (here plane 0).
Plane button lights amber.
ENTER
Step 2 – To save a plane preset, press and hold the Preset button (for 2 seconds).
– To recall a plane preset, press and release the Preset button.
C O N T R O L
PRESET
ESCVIEW
N Saving a preset – Preset button flashes red (shown here).
Recalling a preset – Preset button lights red.
N At this time all lit presets are global presets, not plane presets.
N When saving the current plane configuration to a previously saved plane preset,
the existing data is overwriten.
Follow step 1 of “Saving or recalling a global preset”.
Setting the Front Panel Locks (Executive Modes)
The matrix switcher has three levels of front panel security lock.
Lock mode 0 — The front panel is completely unlocked and
all front panel controls are available. Basic and advanced
features are available.
Lock mode 1 (Executive mode) — All changes are locked from
the front panel (except for setting Lock mode 2). Only View
mode is available.