User`s manual

FOX HD-SDI • Installation and Operation
Installation and Operation, cont’d
2-4
FOX HD-SDI • Installation and Operation
2-5
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
1/4 Rack Width
Front False
Faceplate
1/2 Rack Width
Front False
Faceplate
Both front false faceplates
use 2 screws.
Figure 2-2 — Mounting the transceiver on a standard
rack shelf
5. Secure the shelf to the rack using the supplied machine
screws.
Furniture mounting
The transceiver can be mounted under a horizontal surface using an
optional MBU 125 under-desk mounting kit (part #70-077-01).
Mount the unit under a desk or table as follows:
1. If rubber feet were previously installed on the bottom of
the unit, remove them.
2. Secure the under-desk mounting brackets to the
transceiver with the four machine screws provided in the
mounting kit (figure 2-3).
3. Hold the transceiver with attached brackets against the
underside of the desk or other furniture. Mark the location
of holes for screws on the desk.
4. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
holes in the table or desk at the marked screw locations
from the underside or inside (the concealed side) of the
furniture, where the transceiver will be located.
5. Insert the four wood screws into the pilot holes. Fasten
each screw into the installation surface until just less than
1/4" of the screw head protrudes.
Figure 2-3 — Under-desk mounting
6. Align the installed screws with the slots in the mounting
brackets, and place the transceiver against the surface,
with the screws through the bracket slots.
7. Slide the transceiver slightly forward or back, then tighten
all four screws to fasten it in place.