User Guide Manual

Programmer’s Guide, cont’d
MTPX Twisted Pair Matrix Switchers • Programmer’s Guide
4-10
PRELIMINARY
Command/response table for SIS commands (continued)
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
Save, recall, and directly write presets
N
 • Ifyoutrytorecallapresetthatisnotsaved,thematrixswitcherrespondswiththeerrorcodeE11.
•
The following characters are invalid in preset names: +-,`@=[]{}‘“;:|\and?.
Save current configuration
as a global preset
X1$
,
Spr
X1$]
Command character is a
comma.
Example:
9
,
Spr9
]
Save current ties as preset 9.
Recall a global preset
X1$
.
Rpr
X1$]
Command character is a
period.
Example:
5
.
Rpr05
]
Recall preset 5, which
becomes the current
configuration.
Direct write process —
N
The direct write of a global preset should always be preceded by a clear global preset ties command of that same
preset number, as shown below. In a directly-written preset, each output position’s tied input (or no tied input) remains
unchanged unless overwritten or cleared.
If you do not clear the ties in a global preset number before you directly write a global preset to that number, ties that
are part of the previous version of the specified preset with the same number can unexpectedly become part of the newly-
created preset.
Clear a global preset’s ties
E
+
X1$
P0*!
}
Spr
X1$]
Clear all ties in preset
X1$
.
Directly write a global preset
E
+
X1$
P
X!
*
X@
!
X!
*
X@
%
X!
*
X@
$ ...
X!
*
X@
&
}
The tie all (!), tie RGB (&),
tie video (%), and tie audio ($)
commands are all valid.
Spr
X1$]
Example:
E
+27P0*!
}
Spr27
]
Clearalltiesinpreset27.
+27P12*5!10*09%3*2$3*8&
Esc
Brackets are shown to separate
ties for clarity only. Create
globalpreset27,whichties
video and audio input 12 to
output 5, video input 10 to
output 9, audio input 3 to
output 2, and video input 3
tooutput8.
Spr27
]
Lock (executive) modes
N
See “Setting the front panel locks (Executive modes)” in chapter 3, “Operation”, for more information on the Lock
modes.
Lock all front panel functions 1X
Exe1
]
Enable Lock mode 1.
Lock advanced front panel
functions
2X
Exe2
]
Enable Lock mode 2.
Unlock all front panel
functions
0X
Exe0
]
Enable Lock mode 0.
View lock status X
X^]
N
X!
= Input number 00–(maximumnumberofinputsforyourmodel)
X@
= Output number 01–(maximumnumberofinputsforyourmodel)
X^
= Lock mode 0 = mode 0
1 = mode 1
2 = mode 2
X1$
= Global preset # 0 - 32, 10 maximum (0 = current configuration)