User Guide Manual
3-45
MTPX Twisted Pair Matrix Switchers • Operation
PRELIMINARY
Performing a hard reset from the rear panel
The hard reset function restores the switcher to the original factory default settings.
All user files and settings are maintained. Perform a hard reset as follows:
1
. If necessary, turn off power to the switcher.
2. Press and hold the Reset button on the rear panel while you apply AC power
totheswitcher(gure3-67).
Power
RESET
RESET
Press and hold the Reset button while
you apply power to the switcher.
Release the Reset button.
The switcher flashes the LEDs and
then turns them off.
Continue to hold the Reset button until
all input and output LEDs return to unlit
and the Video and Audio buttons turn on.
Figure 3-67 — Hard reset
N
A hard reset returns the switcher to the default (factory) firmware configuration.
The switcher continues to operate using this firmware until you either cycle
power, in which case the switcher begins to use the most-recently installed
firmware update, or install a new firmware update.