User Guide Manual
Operation, cont’d
MTPX Twisted Pair Matrix Switchers • Operation
3-38
PRELIMINARY
Figure3-55showsthesamevolume(61%)asingure3-54,butdisplayedona
32-input-buttonswitcher,suchasanMTPXPlus3216.
17 18 19 20 30 31 32
The input LEDs display the selected output's audio volume level.
In this example, the lit input buttons indicate 61 percent of the applied audio input.
The unlit input buttons indicate an audio volume attenuation of 26 dB.
–26 dB attenuation, 61% volume
= Lit LED,= unlit LED
Figure 3-55 — Volume display on a 32-input-button switcher
5. PressandreleasetheAudiobutton(gure3-56).
VIDEO AUDIO
I/O
VIDEO AUDIO
The Audio LED stops blinking and lights steadily.
The Video button lights.
Press the Audio button to exit audio mode.
All input LEDs and output LEDs
return to the unlit state.
Figure 3-56 — Deselect Audio mode
Defining the Audio/RS-232 wire pair
N
The audio/RS-232 TP input settings (RS-232 or audio) are protected when front
panel Lock mode 2 is selected. You can view the settings in Lock mode 2 but
you cannot change them from the front panel. See “Setting the front panel locks
(Executive modes)” on page 3-40.
The switcher is compatible with MTPs that transmit and receive mono audio and
those that transmit and receive RS-232 serial data. Y
ou must configure the switcher
for the appropriate audio/RS-232 input for each TP input. Each TP input’s audio/
RS-232 settings can be viewed and changed from the front panel.