User Guide Manual

3-23
MTPX Twisted Pair Matrix Switchers • Operation
PRELIMINARY
Example 6: Saving a preset
The following steps show an example in which the current configuration is saved as
a preset. The steps show the front panel indications that result from your actions.
1
. Press and release the Esc button (figure 3-34).
ENTER PRESET VIEW ESC
CONTROL
Press the Esc button to clear all selections.
The LED
blinks once.
Figure 3-34 — Clear all selections
2. Press and hold the Preset button for approximately 2 seconds until the
Preset LED blinks (figure 3-35).
PRESET
1234
Press and hold the Preset button until
the Preset LED blinks.
If you then save the configuration to a lit preset number,
the configuration data at that preset location will be overwritten.
Lit
(Preset Assigned)
Unlit
(Preset Unassigned)
Preset 17 Preset 18 Preset 20Preset 19
All input and output LEDs with
assigned presets light.
This example shows the action taken on an MTPX 1616.
NOTE
Figure 3-35 — Enter Save Preset mode
3
. PressandreleasetheOutput1button(gure3-36).
ENTER PRESET VIEW
CONTROL
1 2 3 4
The Enter LED blinks to indicate
the need to save the preset.
The Preset LED continues to blink.
Press and release the Output 1 button.
The LED blinks to indicate that this preset
number is selected but not saved.
Preset 17 Preset 18 Preset 20Preset 19
This example shows the action
taken on an MTPX 1616.
NOTE
Figure 3-36 — Select the preset