User Guide Manual

3-5
MTPX Twisted Pair Matrix Switchers • Operation
PRELIMINARY
Control buttons
N
See “Front Panel Operations”, later in this chapter for detailed descriptions of
the following operations.
Primary functions
Action:
Save changes Select Preset mode Select View mode Cancel/escape
Indication:
Blink: save needed Blink: Save preset
Lit: Recall preset
View mode selected Flashes once
ENTER
PRESET
VIEW
ESC
Secondary functions
Port and input
conguration
Action 1:
Select Configuration mode
Action 2/
indication:
Select 9600 baud.
Blink: selected
Select 19200 baud.
Blink: selected
Select 38400 baud.
Blink: selected
Select 115200 baud.
Blink: selected
Front panel
locks
Action:
With Video and
Audio, select Lock
mode 2 and/or
toggle between
mode 0 and mode 2.
Audio Action:
In Audio mode,
decrease input level
or output volume.
In Audio mode,
increase input level
or output volume.
d
Enter button and LED — The Enter button and LED have three primary
functions (•) and three secondary functions ():
Saves changes that you make on the front panel. To create a simple
configuration:
Specify video, audio, or both (see I/O buttons [
h
] and [
i
]).
Press the desired input button (
a
).
Press the desired output button(s) (
b
).
Press the Enter button.
Indicates that a potential tie has been created but not saved.
Indicates that a global preset has been selected to be saved or recalled but
that the preset action has not been accomplished.
With the Preset, View, and Esc buttons, selects Serial Port and Audio/
RS-232 Input Configuration mode. See “Selecting the rear panel Remote
port protocol and baud rate” on page 3-42.
Selects 9600 baud for the rear panel Remote port in Serial Port and
Audio/RS-232 Input Configuration mode and indicates the selection.
See “Selecting the rear panel Remote port protocol and baud rate” on
page 3-42.
With the Video and Audio buttons, selects front panel security lockout
mode 2 or toggles between mode 0 (unlocked) and mode 2. See “Setting
the front panel locks (Executive modes)” on page 3-40.