Setup guide

Refer also to the MTPX Plus User’s Manual at www.extron.com.
j
Ethernet port — If desired, connect a network WAN
or LAN hub, a control system, or a computer to the
Ethernet RJ-45 port.
Network connection• — Wire as a patch (straight) cable.
Computer or control system connection• — Wire the
interface cable as a crossover cable.
N
The factory default IP address is 192.168.254.254.
Power
k
Power connector — Plug the switcher into a grounded AC
source.
Front Panel
AUDIO
VIDEO
I/O
CONTROL
ENTERPRESET
VIEW
ESC
MTPX PLUS SERIES SWITCHER
CONFIG
12
Figure 2-7 — Front panel configuration port
l
Configuration port — If desired, connect a control system
or computer to the front panel Conguration (RS-232) port.
Use an optional 9-pin D to 2.5 mm mini jack TRS RS-232
cable, part #70-335-01.
3
Chapter Three
Front Panel Operation
Creating a Tie
Saving or Recalling a Preset
Setting the Front Panel Locks (Executive Modes)
Defining the Audio/RS-232 Wire Pair (and Configuring the Remote Port)
Viewing and Adjusting the Audio Level
Viewing Ties (and Muting Outputs)
Video Adjustments
MTPX Plus • Installation
Installation, cont’d
2-6
MTPX Plus Matrix Switcher