User guide

MTP U R Series • Installation
Installation, cont’d
16
TP cable termination
N
RJ-45 termination must comply with TIA/EIA T 568A
or TIA/EIA T 568B wiring standards for all connections.
Figure 16 shows the recommended termination of cables with
RJ-45 connectors in accordance with the TIA/EIA T 568A or
TIA/EIA T 568B wiring standards. Either standard can be used
with CAT 5/5e/6, or CAT 7 cable, but ensure that the same
standard is used on both ends of the cable.
Figure 16 — TP cable termination
N
Enhanced Skew-free A/V cable is not recommended for
Ethernet/LAN applications, but is specially designed for
compatibility with Extron’s Twisted Pair products that
are already wired using the TIA/EIA 568 A standard.
DO NOT connect the input RJ-45 to LAN, Ethernet,
outside plant communications, or telecommunications
networks.
N
For proper grounding of CAT 7 cable only, ensure the
shield around each wire and the sheild around the
CAT 7 cable are tied to the RJ-45 connectors on both
ends, in accordance with the connector manufacturers
specifications.
MTP pin assignments for audio, video, and RS-232 transmission
using Extron MTP transceiver standards is shown below.
Pin RGBHV RGBS Component S-Video Composite
1 Red/V sync + Red + R-Y + C + No Signal
2 Red/V sync - Red - R-Y - C - No Signal
3 Mono Audio
or RS-232 +
Mono Audio
or RS-232 +
Mono Audio
or RS-232 +
Mono Audio
or RS-232 +
Mono Audio
or RS-232 +
4 Green + Green + Y + L + Video +
5 Green - Green - Y - L - Video -
6 Mono Audio
or RS-232 -
Mono Audio
or RS-232 -
Mono Audio
or RS-232 -
Mono Audio
or RS-232 -
Mono Audio
or RS-232 -
7 Blue/H Sync + Blue/C Sync + B-Y + No Signal No Signal
8 Blue/H Sync - Blue/C Sync - B- Y - No Signal No Signal
Figure 17 — MTP pin assignments