User Guide Manual

MTP Series • Installation 8
Rack Shelf
Quarter Rack Width
False Front Face Plate
(2) 4-40 x 3/16"
Screws
Eighth Rack Width
False Front Face Plate
Figure 8. Mounting the MTPs on a Rack Shelf
MDA SERIES
DISTRIBUTION AMPLIFIER
Figure 9. Mounting the MTPs on a
Standard Rack Shelf
Rack Mounting Instructions
On the standard rack shelf, the MTP mounts in one of eight locations to the rear of the rack
or in one of eight locations to the front of the rack.
1. Remove the feet from the bottom of the MTP, if installed.
2. Mount the MTP using two 4-40 x 3/16 inch screws in opposite (diagonal) corners to
secure the MTP to the shelf.
3. Install blank panels or other units to the rack shelf.
Furniture or Projector Mounting (All Except AAP Models)
Use the optional mounting kit (furniture, part number: 70-212-01, or projector, part
number: 70-217-01) to mount the MTP as follows:
1. Remove the feet from the bottom of the MTP, if installed.
2. Attach the mounting brackets to the MTP with the machine screws provided (see
figure 10).
• If furniture mounting, proceed to step 3.
• If projector mounting, proceed to step 4.
Under Desk Mounting
Projector Mounting
Ceiling
Projector
Projector
Mounting
Bracket
Mounting
Bolt
Figure 10. Desk and Projector Mounting the MTPs