User Guide Owner manual

MTP R 15HD RSA D • Installation and Operation
Installation and Operation, cont’d
5
2.50 (63.5 mm)
1.50 (38.1 mm)
1.85 (47 mm)
Junction Box
Captive
Screw
Connectors
TP Pigtail
Figure 1 — Decora unit depth profile
To install a new wall box, perform steps 1 through 9 below.
If a suitable wall box is already installed, perform steps 6
through 9 starting on the next page. A UL Listed wall box is
recommended.
1. If a wall box is not available to use for a template, use the
dimensions on page 21 to create a template. If installing
directly into furniture, cut out the center portion of your
template.
N
The drawing on page 21 is not full size or to scale. Do
not scale up or print to use as a template.
2. Place the wall box (or your template) against the
installation surface, and mark the opening guidelines.
3. Cut out the material from the marked area.
4. Insert the wall box into the opening. The box or the wall
plate’s rear connectors should fit easily into the opening.
Enlarge or smooth the edges of the opening if needed.