User Guide Owner manual

MTP R 15HD RSA D • Installation and Operation
10
Front panel features
d
Output video connector — Connect a projector or other high
resolution video device to this 15-pin HD connector.
e
Audio RS-232 output connector — Insert a 3.5 mm, 5-pole
captive screw connector into this jack for mono audio and/or a
RS-232 serial output. See "Audio/RS-232 cable termination" on
page 14 to wire the connector.
N
The receiver auto-detects whether the audio/RS-232 pair
of the TP input is audio or RS-232, converts the signal
content accordingly, and outputs the appropriate signals
on the appropriate pins of this connector.
f
Level and Peaking controls —

Level control — Level alters the video output voltage to affect
the brightness of the displayed image. Adjust the knob while
viewing the displayed image to set the level/boost that provides
the best picture quality.

Peaking control — Peaking affects the sharpness of a picture.
Increased peaking can compensate for mid- and high-frequency
detail loss from low bandwidth system components or
capacitance in long cables. The minimum setting (at the
counterclockwise limit) provides no peaking. The maximum
setting (at the clockwise limit) provides 100% peaking. Adjust
this control to obtain the optimum picture sharpness.
g
Power LED — This LED indicates power is applied to the MTP.