User Guide Owner manual

MTP R 15HD RSA D • Installation and Operation
Installation and Operation, cont’d
9
N
For H Sync + and V Sync +, most devices use
negative sync.
N
Set the Composite Sync, SOG, and Video DIP switches
as shown in the table below for the various input and
output video formats.

Composite Sync (C Sync) switch — Set this switch on (right)
for RGBS or off (left) to output RGBHV or RGsB video. See the
table below.
Output signal
format from
the receiver
Input signal
format to the
transmitter
Receiver's DIP
switch settings
C Sync SOG Video
RGBHV
RGBSRGBHV
RGsB
RGBS
RGsB
RGsB
Component
S-video
Composite
RGBS
RGsB
RsGsBsRsGsBs
Component
S-video
Composite

Sync-on-Green (SOG) switch — Set this switch on (right) for
RGsB video (when the input is RGBHV or RGBS). Set this
switch off (left) to output RGBHV, RsGsBs, or RGBS video.
See the table above.

Video switch — Set this switch on (right) for RsGsBs, RGsB,
component, S-video, or composite video. Set this switch
off (left) to output RGBHV or RGBS video. See the table above.

BI-RS232 — Set this switch on (right) to select bidirectional
communications when serial data is present on the audio/
RS-232 wire pair. Set this switch off (left) to select unidirectional
communications. The default position is off (left).
N
This switch is ignored if audio is present on the
audio/RS-232 wire pair.