User`s manual

MTP DA4 and MTP DA8 • Installation

Installation, cont’d

MTP DA4 and MTP DA8 • Installation

Use 2 mounting holes on

opposite corners

(2) 4-40 x 3/16" screws

False Front Panel

(uses 2 screws)

1U Universal

Rack Shelf

MTP DA SERIES

Figure 4 — Mounting on a 1U universal rack shelf

Furniture mounting

Do not attach the rubber feet. Furniture mount the DA using the

optional mounting kit (part #70-077-01) as follows:

1. Remove rubber feet if they were previously installed on

the bottom of the DA.

2. Attach the furniture mounting brackets to the DA with the

provided machine screws (gure 5).

MTP DA SERIES

Figure 5 — Attaching the furniture mounting

brackets to an MTP DA

3. Hold the DA with the attached brackets against the

underside of the table or other furniture. Mark the location

of the screw holes of the bracket on the mounting surface.

4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)

deep in the mounting surface at the marked screw

locations.

5. Insert #8 wood screws into the four pilot holes. Tighten

each screw into the mounting surface until just less than

1/4" of the screw protrudes.

6. Align the mounting screws with the slots in the brackets

and place the DA against the surface, with the screws

through the bracket slots.

7. Slide the DA slightly forward or back, then tighten all four

screws to secure the unit in place.