User Guide Rev. C Owner manual

E Pre-Peak switch — The Pre-Peak switch alters the twisted pair signal output to
correct for long cable runs (see the table on page 4 for suggested switch settings based
on the transmitted video format and transmission distance).
NOTES:
• The length of the exposed wires in the stripping process is critical. The ideal
length is 3/16 inches (5 mm). If the exposed section is longer, the exposed wires
may touch, causing a short circuit between them. If it is shorter, the wires can be
easily pulled out, even if tightly fastened by the captive screws.
• Do not tin the wires. Tinned wire does not hold its shape and can become loose
over time.
F Output connector — Connect one end of a twisted pair cable to this RJ-45 female
connector on the transmitter. Connect the opposite end of the same twisted pair cable
to the RJ-45 female connector on the receiver (see Twisted Pair Cable Termination
on page 14 to wire the RJ-45 connectors).
ATTENTION: Do not connect these devices to a computer data or
telecommunications network.
MTP 15HD RS Series • Installation and Operation 10