User`s manual

MSW 4V rs and 4SV rs • Installation and Operation
Installation and Operation, cont’d
2-10
MSW 4V rs and 4SV rs
Mode selection
To turn autoswitch mode on:
1. Press and hold the Mode (Input 1) button.
2. Press and hold the Auto (Input 3) button.
3. Release the Mode and Auto buttons simultaneously.
A/V SWITCHER
MODE NORMAL
AUTO
AUTO
SWITCH
1
2
3
4
Figure 2-8 — Turning on autoswitch mode
The Auto Switch LED lights, indicating that autoswitch is
enabled.
To turn autoswitch mode off (Normal mode):
1. Press and hold the Mode (Input 1) button.
2. Press and hold the Normal (Input 2) button.
3. Release the Mode and Normal buttons simultaneously.
A/V SWITCHER
MODE NORMAL
AUTO
AUTO
SWITCH
1
2
3
4
Figure 2-9 — Turning off autoswitch mode
The Auto Switch LED is unlit and the MSW switches to the
previously selected input.
N
In the event that power is disconnected from the MSW, the
unit retains mode and input settings.
Vertical Interval Switching
The MSWs switch inputs during the vertical interval of the
video signal that is on input 1. In a genlocked system, switching
to any input is glitch-free if one of the genlocked devices is
connected to input 1.
3
Chapter Three
Serial Communication
Using Simple Instruction Set (SIS
TM
) Control
Windows-based Control Program
Updating the Firmware