User guide

ES9600 User Guide Chapter 1: Introduction/Quick Reference Guide
12 Version 1.13
Player Connections
All system connections are made at the back of the Players.
Refer to the following sections for details on each of the areas highlighted in this diagram.
AC Power input (Mains power)
The unit features Dual Switched/Fused/Shielded AC power inlets. Use the switches on each module to power-up
or power-down as needed.
Ensure both AC power supplies are connected when the ES9600 is installed in a system.
Though the unit will perform reliably while running on a single AC supply, doing so will defeat the Dual-
Redundant power supply feature important in critical applications.
NOTE: REPLACE FUSE(S) WITH F1.6 AH 240V ONLY.
Cabling Standards
To avoid interference with other equipment, FCC and CE standards require that radio frequency emissions from
electronic equipment are maintained below certain limits. To ensure that radiated emissions from systems using
the 9600 player are maintained below these limits, it is important to use the correct cable types as shown below:
SIGNAL TYPE CONSTRUCTION EXAMPLE CABLE TYPE
AES/EBU audio Coax with braid and 100% foil shield Gepco VPM2000 or Belden 1505A
HD-SDI Coax with braid and 100% foil shield Gepco VPM2000 or Belden 1505A
DVI-I Multi core coax with overall 100% foil shield FRYS.com #: 4557427
Serial COMMs Multi pair with 100% foil shield Belden 1421A
Network Unshielded twisted pair Belden 1583A
GPIO Multi pair with 100% foil shield Belden 1421A