User guide

ES9600 User Guide Chapter 1: Introduction/Quick Reference Guide
10 Version 1.13
Installation, Warnings and Cautions
NOTE: It is expected that the unit will be installed using professional wiring techniques and procedures
appropriate for multimedia systems.
The ES9600 can be mounted in a conventional 19” equipment rack.
Ventilation
NOTE: When installing multiple ES9600s in an equipment rack or other enclosed area it is highly recommended
that the space be equipped with an active cool air intake and warm air exhaust system.
To allow sufficient ventilation and cooling, four conditions must be met:
1. Clear space must be maintained at all times at the sides and to the rear of the player. The clear space
required at each side is 2” (51mm); the clear space required at the rear is 6” (152mm). Cables to and from
the unit are expected within this space but must be managed (cable clips / lacing bar) to prevent the
obstruction of any ventilation holes.
2. The clear space to the sides and rear must also allow air movement vertically within the height of the
equipment rack.
3. The front of the player must remain unobstructed at all times.
4. The air flow into and out of the unit must not be impeded by covering the ventilation openings.
These requirements are usually met by any typical 19” rack mount environment.
Power connection
WARNING: For electrical safety the ES9600 player uses CLASS I construction (as defined in UL - IEC - EN
60065). The player must only be connected to 3 pole MAINS socket outlets with protective earth / ground
connection, using an approved 3 conductor mains power cord (cable) of the type supplied with the player.
Mains disconnect devices
The mains connectors which supply power to this device are considered to be the disconnect devices and in order
to comply with safety requirements must remain readily operable. Do not modify the mains plugs or sockets
supplied with or part of this device in any way that would prevent them from being used to readily disconnect the
device from the power supply for servicing purposes.
WARNING: Physically disconnect BOTH power cables from the Player before opening the case for
servicing.