User`s manual

-0!!MPLIlERs)NSTALLATION

Installation, cont’d

2-14

Audio output

4HISPOLEMMCAPTIVESCREWCONNECTOR

ISUSEDTOCONNECTTHEAMPLIlERTOTHE

SPEAKERS

!LLRIGHTCHANNELINPUTSIGNALSAREMIXED

ANDSUMMEDTOPRODUCEASINGLERIGHT

CHANNELOUTPUTLIKEWISEALLLEFTCHANNELINPUTSIGNALSAREMIXED

ANDSUMMEDTOPRODUCEASINGLELEFTCHANNELOUTPUT

)FTHEFRONTPANELSWITCHISSETTOSTEREOTHEOUTPUTWILLBE

STEREOIFTHEFRONTPANELSWITCHISSETTOMONOTHERIGHTANDLEFT

CHANNELSWILLBEMIXEDANDSUMMEDFORADUALMONOOUTPUT

7ITHANOHMLOADTHEAMPLIlERPRODUCESUPTOWATTS

CHANNEL7ITHAOHMLOADTHEAMPLIlERPRODUCESUPTO

WATTSPERCHANNEL

Do not short the + and - outputs to each other, as

this will damage the ampliﬁer.

The length of the exposed wires in the stripping process

is critical. The ideal length is 3/16” (5 mm). Any longer

and the exposed wires may touch, causing a short circuit

between them. Any shorter and the wires can be easily

pulled out even if tightly fastened by the captive screws.

Do not tin the wires. Tinned wire does not hold its

shape and can become loose over time.

OUTPUT

4/8

OHMS