User`s manual

-0!!MPLIlERs)NSTALLATION
Installation, cont’d
2-12
Remote control
Wiring for remote control
4HISPINCAPTIVESCREWCONNECTORALLOWSA
WALLMOUNTEDAUDIOCONTROLLEROR-EDIA,INK
PRODUCTTOCONTROLVOLUMEANDMUTELEVELS
REMOTELY
/PTIONSFORREMOTECONTROLINCLUDE%XTRONgS6#
0.70-530-026#-!!00.70-396-x16#--!!0
0.70-397-x1AND-,!6#0.60-502-01
4HIRDPARTYKPOTENTIOMETERVOLUMECONTROLLERSCANALSOBE
CONNECTEDTOTHISPORT
N
The length of the exposed wires in the stripping process
is critical. The ideal length is 3/16” (5 mm). Any longer
and the exposed wires may touch, causing a short circuit
between them. Any shorter and the wires can be easily
pulled out even if tightly fastened by the captive screws.
C
Do not tin the wires. Tinned wire does not hold its
shape and can become loose over time.
7IRETHETHEREMOTECONTROLCONNECTORTOTHE6#--!!0AS
SHOWNINTHElGUREANDINSTRUCTIONSBELOW
GND (Pin 3)
Volume Pot
10K Ohms
2K
Vol/Mute
(Pin 2)
10 V (Pin 1)
Mute
Switch
REMOTE
Figure 2-8 — Wiring diagram for remote control
0INIS6$#REFERENCEVOLTAGEs
0IN6/,-54%HASTWOFUNCTIONSs
a )TCANBEUSEDASAVARIABLEVOLTAGEINPUT4HEVOLUME
CONTROLRANGE$#VOLTAGERANGEISTO6WITH
6GIVINGFULLATTENUATIONAND6GIVINGMAXIMUM
VOLUME
b )TCANBEUSEDFORREMOTECONTROLMUTING3OUNDIS
MUTEDWHILETHEMUTEPINISSHORTEDTOGROUND
0INISGROUNDs
N
All nominal levels are at ± 10%
REMOTE
VOL/MUTE
10V50mA