User`s manual

-0!!MPLIlERs)NSTALLATION
2-11
Audio inputs
INPUTS
L
R
L
R
Figure 2-7 — Audio inputs
RCA connectors —4WOCONNECTORS
LEFTANDRIGHTACCEPT
UNBALANCEDLINELEVELAUDIO
SIGNALS4HEINPUTCANBE
STEREOUSINGTWO2#!JACKS
ORMONOUSINGASINGLE2#!
JACKPLUGGEDINTOTHELEFT
MONOSOCKET)FUNUSED
THECONNECTORSAUTOMATICALLY
TERMINATETOLOWERTHENOISE
mOOR
3.5 mm TRS connector —4HIS
CONNECTORACCEPTSUNBALANCED
LINELEVELAUDIOSIGNALS)F
UNUSEDTHECONNECTOR
AUTOMATICALLYTERMINATESTO
LOWERTHENOISEmOOR
Captive Screw connector —4HIS
POLEMMCAPTIVESCREW
INPUTACCEPTSBALANCEDOR
UNBALANCEDMONOORSTEREOLINE
LEVELSIGNALS
N
The length of the exposed wires in the stripping process
is critical. The ideal length is 3/16” (5 mm). Any longer
and the exposed wires may touch, causing a short circuit
between them. Any shorter and the wires can be easily
pulled out even if tightly fastened by the captive screws.
C
Do not tin the wires. Tinned wire does not hold its
shape and can become loose over time.
4HETHREELEFTCHANNELINPUTS2#!423ANDCAPTIVESCREWAND
THREERIGHTCHANNELSAREMIXEDTOPROVIDEASINGLELEFTCHANNEL
OUTPUT4HETHREERIGHTCHANNELINPUTSAREMIXEDTOPROVIDEA
SINGLERIGHTCHANNELOUTPUT
$EPENDINGONTHEPOSITIONOFTHEFRONTPANELTOGGLESWITCH
THERIGHTANDLEFTCHANNELSMAYBEOUTPUTASASTEREOSIGNALOR
SUMMEDANDOUTPUTASADUALMONOSIGNAL
Tip (+)
Sleeve ( )
RCA Connector
Sleeve ( )
Ring (R)
Tip (L)
3.5 mm Stereo
Plug Connector
Balanced audio
Tip
Ring
Tip
Ring
LR
Sleeves
Unbalanced audio
Tip
Sleeve
Sleeve
Tip
LR