User Manual

1
MLM-UDSM • Installation Guide
Extr
on
M
e
d
i
a
L
i
n
k
D
I
S
P
L
A
Y
P
O
W
E
R
V
O
L
U
M
E
MA
X/
MI
N
VCR
DVD
Laptop
D
VD CONT
RO
L
R
E
W
P
L
A
Y
N
E
X
T
P
A
U
S
E
S
T
O
P
T
x
Mounts to Furniture
AAP Openings
and Optional AAP
Slides Out
AAP Openings and
Optional AAP Device
MLC 206
MLM-UDSM Installation Guide
About the MLM-UDSM
The Extron MLM-UDSM is an under desk/table mounting enclosure for the
MediaLink™ Controller (MLC 206) that provides a way to slide the MLC out of
the way (like closing a drawer) when not in use. The MLM-UDSM also provides
four single-space Architectural Adapter Plate (AAP) openings for attaching control
modules or other AAP devices.
It is available in three colors: gray (Extron Part #60-394-01), black (#60-394-02), and
white (#60-394-03).
The illustration below shows
the MLM-UDSM with
an optional MLC
206 MediaLink
Installing the MLM-UDSM
Attach the mounting plate to the furniture.
The furniture should be at least 3/4" (1.9 cm) thick if you use the provided screws.
1. Hold the top of the mounting plate against the underside of the desk or table
where you want to install the MLM-UDSM, and mark the locations of the
six screw holes. Make sure that the front of the mounting plate faces and is
parallel to the outer edge of the furniture.
N The front edge of the sliding enclosure and the front of the mounting plate will
be aligned after installation; the handle protrudes 5/8" (1.6 cm) from that edge.
2. Drill 1/4" to 3/8" (6 to 9 mm) deep pilot
holes in the marked locations. Use
a drill bit that is at least two
sizes smaller than the screw
thread diameter.
3. Fasten the plate
to the
furniture
with the
provided
#8 wood
screws.
(6) #8 Screws
Front