Installation User guide

SIS
™
Programming and Control, cont’d
MLC 226 IP Series • SIS Programming and Control
5-16
PRELIMINARY
Command/response table for SIS commands (continued)
Command ASCII (Telnet)
(host to switcher)
URL Encoded (Web) (host to switcher)
Response (switcher to host)
Additional description
Ethernet data port confi guration and use
Set global IP port timeout period
24
E
1*
X6(
TC
}
W1%2A
X6(
TC
|
Pti 1*
X6( ]
The global port timeout is the default timeout period for all Telnet sessions. X6(
= IP connection timeout period in
seconds. Each step is specifi ed in 10-second intervals (1 - 65000, default = 30 = 300 seconds). If no data is received during the specifi ed period, the Ethernet connection closes. Responses are returned with leading zeros. This timeout period is applicable only when the MLC is connected via Ethernet, and you must be logged in as an administrator to change this setting.
View global IP port timeout period
E
1TC
}
W1TC
| X6(
]
Set current port’s timeout period
13, 24
E
0*
X6(
TC
}
W0%2A
X6(
TC
|
Pti 0*
X6(
]
The current port timeout period applies to the currently open Telnet session only. When you start another Telnet session, it uses the default global port timeout period. X6(
= timeout period in seconds. See
the description above. This variable is applicable only when the MLC is connected via Ethernet. If the MLC is connected via RS-232 protocol, only the global timeout commands apply, and any commands involving
X6(
return the E13 error response.
View current port’s timeout period
13
E
0TC
}
W0TC
| X6(
]