Manualshelf

Installation User guide

ManualsBrandsExtron Electronics ManualsHardwareMLC 226 IP Series
81828384858687888990
5-9
MLC 226 IP Series • SIS Programming and Control
PRELIMINARY
Command/response table for SIS commands (continued)
Command ASCII (Telnet)
(host to switcher)
URL Encoded (Web)
(host to switcher)
Response
(switcher to host)
Additional description
Volume adjustment (discrete, for volume mode = 0)
Set the overall output volume
level
14
X*
V
X*
V Vol
X*]
This command sets a specifi c volume level
for the audio output at either the display
device or via an optional slaved Extron
MediaLink (MLS) switcher.
X*
= volume level (0 to 100). Default
volume = 25.
When no MLS is detected at the MLS port,
the maximum volume level is limited by the
max. volume range command (
X?
*47#).
N
The MLC responds with an E14 (not valid for this confi guration) error if you attempt to set a discrete volume level while the
MLC is in increment/decrement volume mode (volume mode 1).
Example:
27V 27V
Vol027
]
Example: set volume to 27.
Increment the volume +V %2BV
Vo l
X*]
Increase audio output.
Decrement the volume -V %2DV
Vo l
X*]
Decrease audio output.
View the volume level V V
X*]
Show the output volume.
Volume adjustment (for volume mode = 1)
Increment the volume +V %2BV
Vo l
X*]
Increase audio output.
N
The MLC responds with an E14 (not valid for this confi guration) error if you attempt to set a discrete volume level while the
MLC is in increment/decrement volume mode (volume mode 1).
Decrement the volume -V %2DV
Vo l
X*]
Decrease audio output.
View the volume level V V
X*]
Show the output volume.
Audio mute
Mute on 1Z 1Z
Amt1
]
Mute all audio outputs. This is not the same
as selecting input 0.
Mute off 0Z 0Z
Amt0
]
Unmute all audio outputs.
View the audio mute status Z Z
X%]
Show the status of audio mute.
X%
= 0 (off) or 1 (on).
Relay functions
Force relay on
X!
*1O
X!
%2A1 O Rly
X!
*1 Turn relay number
X!
on.
X!
= 1-6, to
match the corresponding relay number.
Force relay off
X!
*0O
X!
%2A0 O Rly
X!
*0
]
Turn relay number
X!
off.
Toggle relay
X!
*2O
X!
%2A2O Rly
X!
*
X%]
Toggle relay
X!
on/off.
X%
= 1 (on) or 0 (off).