Installation User guide

B-9
MLC 226 IP Series • Firmware Updates
PRELIMINARY
Resetting the MLC and restoring its confi guration
After a fi rmware update you must reset the unit. Resetting the MLC also removes
confi guration information, so replace the MLC’s confi guration after resetting.
1. Perform a ZY reset, which is an absolute system reset excluding IP settings (IP
address, subnet mask, gateway IP address, unit name, DHCP settings, port
mapping). This allows you to maintain communication with the MLC.
• If using Telnet or HyperTerminal, enter
E
ZY
}
.
• If using a Web brower connection, enter W ZY
|
.
N
This command is supported by MLCs with fi rmware of version 1.03 or higher.
2. Using Global Confi gurator, restore (build) the previously saved project to the
MLC.