Installation User guide

Special Applications, cont’d

MLC 226 IP Series • Special Applications

6-8

PRELIMINARY

In this example (shown above and described in the following procedure), the

DVD/VCR player’s output is connected to switcher/projector input 2, which is

associated with the MLC 226 IP’s input 2 button.

Detailed instructions on basic conﬁ guration via software are available in the

MLC 226 IP Series Setup Guide and in chapter 4 of this manual.

The numbers in the following sample screen images correspond to the

procedure’s step numbers.

To conﬁ gure a single MLC 226 IP input button to control the IRCM-DV+ and DVD-

VCR player, follow this procedure:

1. Connect cables between the MLC, input/output devices, and the PC as

described in chapter 2, “Installation.”

2. Install and start the Global Conﬁ gurator software and create or open a GC

project, and add an MLC to the project, if that has not already been done. For

instructions, refer to chapter 3 of the MLC 226 IP Series Setup Guide, steps 1, 2,

and 3.

3. In Global Conﬁ gurator, add device drivers and assign them to the Projector

RS-232/IR port and the IR/Serial Output ports. For instructions on these

tasks, refer to chapter 3, step 5, of the MLC 226 IP Series Setup Guide. In this

example the DVD-VCR player will be connected to IR/Serial Output port A.

4. Click on the Front Panel tab.

5. Click the input button (button 2 for this example) that will be used with the

DVD-VCR player.