Instruction Manual

SIS
™
Programming and Control, cont’d
MLC 104 Series • SIS
™
Programming and Control5-30
PRELIMINARY
Command/response table for SIS commands (continued) Command ASCII (Telnet) URL Encoded (Web) Response Additional description
(host to switcher) (host to switcher) (switcher to host)
Read button LED status
Esc
LC W LC
|
X212
Set button LEDs to blink slowly
24
Esc
1*
X212
LX W 1%2A
X212
LX
|
Lbk*1*
X212
Read which button LEDs are set to blink (whether slowly or fast)
Esc
1LX W 1LX
|
X212
Set button LEDs to blink fast
24
Esc
2*
X212
LX W 2%2A
X212
LX
|
Lbk*2*
X212
Read which button LEDs are set to blink fast
Esc
2LX W 2LX
|
X212
The command to make a button LED blinik fast takes precedence over the comand to make it blink slowly. If a button’s LEDs are set to blink both fast and slowly, the LED will blink fast.
Reset (zap) commands and erase commands
Erase the flash memory
24
Esc
ZFFF WZFFF
|
Zpf
Reset all device settings to factory defaults
24
Esc
ZXXX WZXXX
|
Zpx The “reset all settings” command
does
not affect IP settings or flash memory.
The ZXXX command does not reset any IP-related settings such as the IP address, subnet mask, and gateway IP address. It also does not affect user files stored in flash memory.
Absolute system reset
24
Esc
ZQQQ WZQQQ
|
Zpq Reset all settings/memories. The ZQQQ
command resets everything (all settings, adjustments, PINs, the IP address, and subnet mask) to the factory default values. Files in flash memory are also erased by this command. The firmware version doesn’t change. The IP address is reset to 192.168.254.254, the subnet mask is reset to 255.255.0.0. This command is identical to reset mode 5, discussed in “Resetting the unit” in chapter 2.