Instruction Manual

5-19MLC 104 Series • SIS
™
Programming and Control
PRELIMINARY
Command/response table for SIS commands (continued) Command ASCII (Telnet) URL Encoded (Web) Response Additional description
(host to switcher) (host to switcher) (switcher to host)
Set GMT offset
24
Esc
X3
CZ W
X3
CZ
|
Ipz
X3
Set the Greenwich Mean Time (GMT) offset
value (
X3
) for the MLC’s location. GMT
offset (-12.00 to +14.00) represents the time difference in hours and minutes (+/-hh:mm) relative to Greenwich, England. The leading zero is optional. For example, 5:30 = 05:30. Do not use a plus (+) sign if the GMT offset is positive.
Read GMT offset
Esc
CZ WCZ
|
X3
Set daylight saving time
24
Esc
X34
CX W
X34
CX
|
Ipx
X34
X34
= Daylight saving time (DST) is a
region-specific 1-hour offset that begins in spring and ends in fall. DST should be turned off in Hawaii, American Samoa, most equatorial regions, Guam, Puerto Rico, the Virgin Islands, the eastern time zone portion of the state of Indiana, and the state of Arizona (excluding the Navajo Nation). 0 = off/ignore 1 = USA on – starts on the first Sunday of April at 2 am and ends on the last Sunday of October. For example, time in California is GMT -8:00 from April to October and GMT - 7:00 from November to March. 2 = Europe on – begins on the last Sunday in March, ends on the last Sunday in October. 3 = Brazil on – beginning and ending dates vary from year to year. DST is not used in equatorial areas.
Read daylight saving time
Esc
CX WCX
|
X34
Set DHCP on
24
Esc
1 DH W1DH
|
Idh 1
Set DHCP off
24
Esc
0 DH W0DH
|
Idh 0
View DHCP mode
Esc
DH WDH
|
X5
X5
= 0 (off) or 1 (on).
Set IP address
24
Esc
X14
CI W
X14
CI
|
Ipi•
X14
X14
= IP address (xxx.xxx.xxx.xxx). Leading
zeros in each of the four fields are optional in setting values.
Read IP address
Esc
CI WCI
|
X14
Leading zeros in each of the four fields are
suppressed in returned values.
Read hardware address (MAC)
Esc
CH WCH
|
X18
X18
= hardware (MAC) address (xx-xx-xx-
xx-xx-xx).