Setup Guide Instruction Manual

ii
MLC 104 Plus Series • Table of Contents
Table of Contents, cont’d
68-1289-01 Rev. D
11 08
All trademarks mentioned in this manual are the properties of their respective owners.
Step nine: assign serial device drivers ................................ 3-14
Step ten: assign IR drivers ................................................... 3-15
Step eleven: congure the front panel .............................. 3-16
Button caption .....................................................................3-16
Button tool tip ......................................................................3-16
Button repeat rate ................................................................3-17
Button modes .......................................................................3-18
Switcher input ......................................................................3-19
Button operations ................................................................3-20
Clear, reset, and auto ll captions .......................................3-24
Step twelve: congure associated control modules ......... 3-25
Step thirteen: create a shutdown schedule ....................... 3-27
Step fourteen: create a lamp hour notication (IP models
only ...................................................................................... 3-29
Step fteen: create a disconnect notication
(IP models only.................................................................... 3-31
Step sixteen: build the Global Congurator le ............... 3-33
Step seventeen: upload the Global Congurator le ....... 3-34
Step eighteen: launch GlobalViewer (IP models only ...... 3-35
Testing the GlobalViewer pages ......................................... 3-36