User Guide User guide

MGP Pro Series • Remote Configuration and Control 83
FIG_Comm Type Selection
Figure 27. Comm Port Selection Window with TCP/IP and RS232 Tabs
• Select the TCP/IP tab if you are using the LAN port. If you will be uploading
firmware, you should use this connection.
• Select the RS232 tab if you are using a serial ports. (The front panel port supports
only RS-232. The rear panel 9-pin serial port supports RS-232 and RS-422.)
3. On the selected tab, enter the information for your communication type and click OK.
• TCP/IP: Enter your MGP Pro IP address, Telnet port (the default is 23), and a
password if required.
• RS232: Select your computer communication port from the Port menu, and the
baud rate from the Speed (baud) menu. All other parameters are preset.
Figure 28. MGP Series Control Program Main Window (MGP 464 Pro)
4. For information on configuring the MGP Pro using the software, see the help file. To
access the help file, select Contents from the Help pull-down menu or press the <F1>
key.